Home » Computing » Peripheral » Netgear RangeMax Dual Band Wireless-N Router WNDR3300

Netgear RangeMax Dual Band Wireless-N Router WNDR3300 review



Our Score


Review Price £85.00

Netgear has been quiet on the wireless front for far too long. While the competition has been busy churning out variations on the wireless-N theme Netgear's last significant product was its Gigabit-equipped WNR854T, which we reviewed over a year ago. The latest WNDR3300 not only remedies this situation but it delivers an interesting mix of features with dual-band wireless at the top of the list.

For design Netgear has taken a leaf out of Belkin's book as it has ditched its clinical white casings and gone for a slinky gloss black finish top and bottom. The router has no less than eight aerials inside, which link up with the trademark blue dome on the top. These are supposed to flash to tell you which ones are active and where the signals are coming from, but after a while we just found it irritating as the LEDs are very bright.

Unfortunately, unless you disable the radios you're stuck with them as the option on previous models to switch the dome LEDs off from the management interface is no longer present. However, the dome now has another purpose in life as it can be used for push-button WPS (WiFi Protected Setup) connections with wireless clients.

A modicum of status LEDs are sprinkled across the front panel with indicators provided for the LAN and WAN ports, both 5GHz and 2.4GHz radios and power. Alas, Gigabit Ethernet isn't on the menu as all you get at the rear is a quartet of switched Fast Ethernet ports and a separate RJ-45 WAN port that accepts a suitably equipped ADSL or cable modem. This does make the top claimed speeds of 270-300Mbps rather academic as these will never be achieved between LAN and WLAN users.

Netgear has installation down to a fine art as the CD-ROM based setup utility helps you connect the router and checks your Internet connection is working. If, like us, your modem is already configured with an ISP account and running a DHCP server then there's virtually nothing to do except plug everything together as instructed. If the setup utility likes what it sees it'll transport you to the router's main web interface and lets you get on with further configuration.

On first contact with the router, the web interface does a quick reconnoiter of Netgear's support site to check for new firmware upgrades and then lets you into the interface. For wireless settings you have an interesting selection of modes. You can have simultaneous support for the 5GHz and 2.4GHz ranges each supporting 270Mbps and 54Mbps speeds respectively or you can go for 270Mbps 2.4GHz instead. You can also opt for single channel wireless-N for both modes which drops speed to 130Mbps. To be honest none of these speeds are achievable in the real world but at least Netgear has stopped the dubious practice of advertising these speeds on the product packaging.

Next page


March 21, 2010, 6:35 am

Do no purchase this wireless router.

When purchased, the setup wizard failed repeatedly. After an hour on the phone to India to someone who could not speak or hear me, it was determined that the software provided with the hardware was not compatible (after figuring out that it had nothing to do with my XP operating system). I manually logged into the IP for the router and set it. One month later, I began getting intermittent signal drops. I tried to reset the system and again contacted India for support. After another hour on the phone, their diagnosis was that my cable modem has a problem. The cable modem is fine, and I could tie into it directly without a problem. The cable modem has a dynamic IP, so if the router can not handle that - then why does it claim that it can? I bought a LinkSys wireless router and was up and running in 10 minutes. The older model LinkSys supposedly has a shorter range, but in fact the signal is just as good all over the house as the Netgear system was when it worked.


1 - Software incompatible with hardware, had to contact support and manually set up

2 - Hardware began to fail after one month

3 - Technical support difficult to understand and not capable of figuring out problems - like to blame it on something else.


June 28, 2011, 2:48 pm

I wnt for this router after reading this article.


I use it with both G and N gear (MacBooks (N), iPhones (G), Wii (G)).

You want to run it in simultaneous mode if you want to get the best perfomance for your N stuff from it. Running it in single mode, 2.4 GHz only, will drop everything down to the performance of your G rated equipment.

hyman sterling

October 25, 2013, 10:08 pm

i have this router and love it i have 2 hard wire connections and about 6 to 7 wireless devises runing at any given time with no problems what so ever if i ever have a problem the user interface is simple enough for port forwarding and the like .i have owned this router for a little over 2 years and its time for a upgrade but for what it is i love it.

comments powered by Disqus