Dell 1320c Colour Laser Printer - Dell 1320c

By Simon Williams

Reviewed:

Summary

Our Score:

7

User Score:

Dell claims up to 16ppm for black text print and up to 12ppm for colour. Unusually, in our tests colour print was marginally quicker than mono black print. Our five-page text document completed in 43 seconds, giving a real world print speed of 6.98ppm, but the colour text and graphics prints took four seconds less at 39 seconds, a speed of 7.7ppm. The photographic 15 x 10cm colour print took 19 seconds. None of these print speeds is particularly spectacular, even for a comparatively inexpensive colour laser printer such as this.

Print quality is generally pretty good. Black text is dense and well formed even though the printer's resolution at 600dpi is lower than some of its rivals. Solid colour, as in business graphics, is also generally good but we did notice some slight mis-registration of black text over-printing colour backgrounds. That said, in normal use this won’t be a problem.

The photographic print wasn’t spectacular, but no worse than from several other colour lasers in this price bracket. Interestingly, the 1320c made a better job of the image when set to automatic colour than when we went into the driver and chose colour correction for landscape photos.

Total running costs are confused by Dell’s way of handling maintenance. While you can buy toner in either of two cartridge capacities - 1,000 and 2,000 pages - the PHD and transfer belt will also run out at some stage. Dell says this is covered by its service package, which is free in the first year and costs a very reasonable £140 to extend up to the end of the fourth.

To work out overall running costs, we added the toner costs to a notional duty cycle of 100,000 pages over four years (probably high for a small-business, colour laser) using Dell's four-year service option. This produced a page cost of 2.41p for 5% black print and 9.40p for 20% colour. Black print cost is reasonable, but that figure for colour is high, the majority of it coming from the £44, high-yield colour toner cartridges.

Verdict

There are good and bad things to say about Dell's 1320c colour laser. It's nicely turned out, runs quietly and produces good quality print, but is comparatively expensive to run and lacks any real expansion potential. To add colour to business documents in a small office it would be good value, but it's unlikely to keep up if your business expands.

peterbiddlecombe

June 15, 2009, 7:45 pm

"Although there are no instructions to perform manual duplex, if you remove the pages from the output tray and insert them in exactly the same orientation into the feed tray, everything works fine."





WRONG. If you've printed more than one page you have to reverse the order of the pages. You also have to rotate through 180 degrees between lifting from output tray and putting back into the feed tray. Apart from that, everything else is true.

Alan Crook

February 9, 2010, 6:46 pm

It all depends on which edge you choose to flip on. If you choose short edge then the back copy copy comes out upside down.

NightHawk

September 18, 2010, 10:21 pm

I have printed an 11 page document on this printer using the Duplex option in the printer properties window.





As Crook says above, make sure you specify "Flip on Long Edge" in the duplex panel and keep the same orientation of the output stack to the input tray. Dont turn or flip or swivel.





That is if you want a normal printout. like a book, stapled on side edge.





If you want a flip chart type, then use "Flip on Short Edge". The turned page will be upside down when viewed in the stack, but right way up when stapled along the top edge.

comments powered by Disqus