Setting up the camera is very easy and the process follows that of most other IP camera’s out there: plug the camera into the mains, attach it to your network using a wired connection, install the software, and wait until the software finds your camera. The software will search for and display a list of all your attached cameras and if there is an IP conflict you can change the camera’s IP address from here. Once a valid IP is assigned to your camera, you can then double click it and your default browser will open and go to the camera’s web interface. The web interface enables you to control every aspect of the camera from your browser and, once you’ve set-up Internet access, you can access it from anywhere around the world.
Opening the web interface you are greeted by a still picture of the current view. Above this are options for viewing the video feed, using either ActiveX or Java, and opening the system administration menu.
In the video view mode a stream of video is shown at its native resolution with a series of controls to its left. You can pan and tilt the camera and you can specify how much the camera turns with each increment. You can also zoom in using the 4x digital zoom and turn on upload or email video recording – these will send a recorded video stream to your specified FTP server or email address ready for viewing later or keeping for your own records.
In the system administration you get a very comprehensive list of options for video, network, user access, FTP upload, and email notification, some screen shots of which you can find at the end. Of particular note are support for wireless encryption using both WEP and WPA, UPnP support, scheduled video upload, and, scheduled email upload.
Being a fixed focus lens it takes a bit of effort to get the camera setup – especially if there’s only one of you – but once focused the picture is quite acceptable, assuming you’re in a well lit area, with only the slightest hint of barrel distortion. Turning the camera away from the daylight streaming through our windows and towards the darkness under my desk, the gain boost required to cope with the low light level introduced a horrible amount of image noise rendering the image mostly unusable. So, though the sensor may be able to detect light levels as low as 2.5 lux it doesn’t mean you get a decent picture at that illumination. Moreover, the viewing angle isn’t particularly good and you will probably find yourself doing a lot of panning and tilting if you’re trying to track an object. Comparing to the camera on my Sony Ericsson K800i – a fairly standard wide angle snapshot camera – I was getting about half the viewable angle.
Video is compressed using the M-JPEG standard which is nowhere near as efficient as MPEG4 but does capture greater detail per frame. Using the full 640 x 480 resolution requires the frame rate to drop to only 10fps and lag is very pronounced – even on our Gigabit network. Dropping to 320 x 240 results in much smoother video and lag becomes minimal. Experimenting with the compression settings and resolutions should enable most users to find a reasonable compromise between picture quality, bandwidth, and frame rate.
Included in the package is TRENDnet’s IP camera surveillance software which is called IPView. The previous version of this software impressed me with its simple layout and fairly intuitive interface. Unfortunately, TRENDnet has taken a step back with its latest iteration and has ended up with something reminiscent of Winamp with a particularly bad skin on it. Buttons aren’t labelled and require a mouse over pop-up to indicate what they do and there’s no normal drop down menus to fall back on. Put simply, absolutely nothing is intuitive. Fortunately, given the relatively simple set of tasks this software has to do, it doesn’t take long to become familiar with its idiosyncrasies and get up and running. It can monitor up to four cameras, has options for motion detection, and you can access the cameras web interface for changing all the settings therein.
The TRENDnet TV-IP400W offers an impressive set of features for such a cheap IP camera and it backs it up with a solid level of performance in well lit areas. However, the poor low light level performance and lack of audio do limit the applications for which this camera will be useful. Also, the less said about the software, the better.
Unlike other sites, we thoroughly test every product we review. We use industry standard tests in order to compare features properly. We’ll always tell you what we find. We never, ever accept money to review a product. Tell us what you think - send your emails to the Editor.