- Page 1 Ricoh Aficio GX3000s Inkjet MFP
- Page 2 Ricoh Aficio GX3000s Inkjet MFP
- Page 3 Feature Table
- Page 4 Print Speeds & Running Costs
Ricoh itself can’t seem to decide how fast the Aficio GX3000s can print. In the spec sheet and on its website it claims 29ppm for both black and colour in draft mode, but in the CD-based manual it only claims 18.5ppm, again in draft mode.
In fact, in day-to-day printing, you shouldn’t expect more than around 10ppm. Our five-page black text document completed in just 32 seconds, which is 9.38ppm, but increasing the document size to 20 pages only increased the print speed to 10.17ppm. This is because there’s very little processing time between sending the job and the first page starting to print. Ricoh’s rasteriser is commendably quick off the mark.
Printing duplex reduces the speed, but only to 8.39spm. This is fairly remarkable for a duplex inkjet, as most have to wait at least 10 seconds before printing the second side of each page to allow for ink drying. Also, our 15 x 10cm photo print took 2:10 printed in quality mode, but only 1:09 in speed mode.
The difference in print quality is noticeable, but for most everyday prints, the speed mode will probably suffice. In both modes, colours are a little pallid in comparison with Canon or HP, but quite acceptable and there’s plenty of detail, particularly in shadowed areas of the prints.
Colour graphics on plain paper are vivid, though there’s a little banding obvious and a colour photocopy loses a lot of colour depth in reproducing the colours. Black text over coloured backgrounds is also much worse in copies than in original prints, where registration is tight.
Black text print is disappointing. There’s obvious feathering of the ink into the paper nap and some characters exhibit banding, with paper showing through the black print in many places. Emboldened characters appear fuzzy and some of the loops in characters like ‘e’ and ‘a’ become filled.
The black cartridge for this machine offers 1,500 pages and each of the colour cartridges can provide 1,000, so page costs come out at 2.59p for black and 11.55p for colour. The black page cost is not excessive, but over 11p per ISO colour page is at the high end of the range.
The Aficio GX3000s is a big, robust, office inkjet, which certainly has the speed to warrant its place in a shortlist of colour laser replacements. Text quality is not nearly as good as a typical laser, however, and is pushed to keep its place among other inkjets, too. The 300dpi scanner (600dpi only in black and white) is just enough for OCR, but colour copies lack definition. If print speed is the prime factor in your choice, this machine may still rate, but if it’s print quality you’re looking for, you should try elsewhere.