It’s quite a looker too. I’ve had issues with Viewsonic styling in the past, but there’s nothing to upset me here. In fact, of the trio of 22in displays I’ve seen this one is the definitely the most stylish. The bezel is surrounded by silver edging, which curves outwards at the top centre and at the bottom on both sides. On the right hand side this curvature accommodates one round button and four longer ones, again with a shiny silver finish. The former is for muting the speakers while the others are for controlling the OSD. The silver theme is added to with two more touches, the power switch with a cool blue light at its centre and the Viewsonic logo above this. The classic Viewsonic pelicans are located at the top left.
The Viewsonic makes a real feature of its built-in speakers, which are quite evidently underneath the logo. Round the back you’ll find DVI and D-Sub ports, along with an audio input for the speakers. There’s no HDCP compliance listed for the DVI socket in the documentation, which will be a problem if you plan to watch HD DVD or Blu-ray on your PC.
The stand has two ties for cable management and best of all it has height adjustment, which is a major differentiator from the Mirai and IIyama. And when I say it has height adjustment, it really has height adjustment. It’s doesn’t go as low as the Dell 2407, but it does go a lot higher – in fact higher than any monitor I’ve seen. If you’re a giraffe, this is the screen to get. The display can also fully pivot with only the cables attached preventing it from spinning a full 360 degrees. The clever part is the way Viewsonic has done this. On say, the Dell 2407, the monitor stand rotates inside the base. On the VG2230wm it’s the whole monitor that turns round – Viewsonic has simply weighted the base and made it circular so that it can spin. It’s neat and effective and obviously cheaper too.
When it came to setting the screen up, I quickly discovered that while the OSD buttons at the bottom right look cool, they’re a serious pain to use. The problem with having them discreetly placed on the right hand side is that they’re hard to access and you really need to crouch right down to see what you’re doing. To start with I found it awkward and fiddly to use which is telling as I’m familiar with the layout of the Viewsonic OSD. I missed the easy to use forte Manager software supplied with the LG L1900R Ring Monitor.
From the OSD you can adjust the colour temperature, and contrast and brightness unless you’re using the sRGB setting, which locks them down. You’ll probably want to adjust the colour temperature depending on your ambient conditions, as it does have a dramatic effect on the way the displays looks. The 9300K setting made the screen look overly blue, so I switched between using 5400K and the sRGB settings, depending on ambient light conditions.
The panel is only 6-bit, so is limited to 16.2m colours using dithering techniques. However, while colours weren’t necessarily accurate, they were pleasingly vibrant making this a screen you’ll enjoy looking at.