Summary

Our Score

8/10

Review Price free/subscription

:

The growth in NAS (network attached storage) has been quite phenomenal this year but the one area few products if any tackle is portability. SMC’s latest SMCWAPS-G aims to deliver such a solution as this compact little slab of plastic is designed to allow external USB storage devices to be shared over wired and wireless networks. In fact, you don’t even need a separate storage device as the box also has an internal Ultra DMA 133 IDE interface which accepts a 2.5in hard disk.

Empty, the unit weighs a mere 196gms and measures a very modest 92 x 162 x 25mm. At the rear you get a pair of USB 2.0 ports plus a Fast Ethernet port and the chassis incorporates an 802.11g wireless access point. A single, detachable aerial screws in at the back and the unit is powered by a reasonably small supply which adds a further 154g to your running weight.



The smoked plastic panel in the centre of the unit appears to be merely cosmetic but the unit does come with a stack of status LEDs. You get no less than eight indicators showing power, LAN, WLAN and USB port status along with internal HDD status and activity plus a warning light for when hard disk capacity is reaching its limit or there is a disk error. Two recessed buttons at the side control power and the backup feature, while pressing both together will reset the unit back to factory defaults.

The backup button will prove useful as it initiates a copy of data on any attached USB device to the internal hard disk. This is similar to the Backup Button feature offered by Infrant’s ReadyNAS NV but you do not have any options to customise operations. Pressing the button will simply copy everything from the USB disk to a new folder named with the date.

One really silly design fault is that the two USB ports are so close together that it’s impossible to fit two USB flash drives at the same time. The only way to do this is to use a pair of USB extension cables but even here it’s a tight fit. Adding an internal hard disk is easy enough as you remove a couple of screws at the back and unclip the entire front panel. We slipped an IBM 2.5in drive inside and had the lid back on in a couple of minutes.

Installation takes a matter of minutes and SMC supplies a small utility that searches for these devices on the network. It’s a handy tool but the window is actually too small and once you know the unit’s IP address it’s easier to swap over to a standard web browser. A wizard takes you through initial configuration where you can choose DHCP server or client functions, set the time and date, activate the wireless services and choose a mode.

Next page
comments powered by Disqus