Review Price £116.39
OKI MB260 LED Multi-Function Printer - OKI MB260
Physical set up is as easy as pulling down the front panel and inserting the combined drum and toner cartridge. Annoyingly, if you open either the main paper tray or the front panel to change the cartridge, a continuous warning beep goes off until you close them again. A 20 second warning would be more than enough.
Software installation includes setup of OKI's Companion Pro applet, which is effectively a front-end for its own supplies monitor and the bundled copy of PaperPort LE. This is quite a sophisticated document management and OCR application for a machine at this price and makes everyday jobs, such as scanning to Word or printing from file, very straightforward.
We really could believe OKI's speed rating of 20ppm, if it wasn't for the long processing time evident before the first page starts to feed. Because the MB260 is a GDI printer, not using PCL or PostScript, the overall speed is dependent on the processing power of the host PC it's connected to. On our Athlon 64 X2 4200+ it took 18 seconds to process the five-page test document and 22 seconds for the 20-page one.
The actual paper feed is quite quick, compensating for these slow off-the-mark times and giving real-world speeds of 8.57ppm and 14.81ppm for the two documents. The five-page text and graphics job gave exactly 10ppm.
A single page copy took 21 seconds and a 15 x 10cm photo print on A4 paper took 27 seconds. Interestingly, the same size print taken from a USB drive was much slower, at 53 seconds.
The quality of prints from the machine varies with the source material. Black text is clean and light, with a good mix of dense black where it's needed and more delicate characters in body copy.
Greyscale graphics show good levels of variation between tones, but some striations in areas of solid fill. Photographic reproduction also shows these bands, but is otherwise pretty good, given the 600dpi resolution of the machine. Photocopies of text are fine, but copying greyscale originals produces blotchy results.
The drum and toner cartridge is available in two capacities, 3,000 and 5,500 pages and using the higher capacity version gives a cost per page of 2.95p, including 0.7p for paper. This is broadly on a par with other laser multifunctions at a similar price, though a little high compared with equivalently priced inkjets.
This is a really nice machine for personal use as a printer, copier and scanner. If you don't need colour, it's really cost-effective as a SOHO device, even though its GDI processing slows it up on older computers. Print quality is adequate, better on text than greyscale graphics. At the price, you'll find it hard to improve on the MB2600 as a whole.