Summary

Our Score

6/10

Review Price free/subscription

Biostar TA790GX A3+

We've seen a steady stream of Biostar motherboards that support Phenom in recent times and in many respects they feel as though they have been leading up to the TA790GX A3+. The Biostar TA790GX A2+ that we reviewed last year uses a 790GX chipset with SB750 Southbridge but it supports Socket AM2+ with DDR2 memory. Meanwhile, the Micro-ATX TA790GX XE that we saw more recently is effectively a smaller and cheaper version of the TA790GX A2+ as it continues to use Socket AM2+ with DDR2.

The biggest difference between the two models is that the full sized motherboard supports dual graphics slots with CrossFireX while the Micro-ATX model only has room for a single graphics slot. By contrast this TA790GX A3+ supports a Socket AM3 processor with DDR3 memory and while the increase in memory clock speed from 1,066MHz to 1,333MHz is welcome it is only part of the equation.
/94/7f4e94/2b46/11457-biostarta790gxa3angle1.jpg
We have previously found that the combination of a Socket AM3 Phenom II in a Socket AM3 motherboard uses significantly less power than it does when you install the same processor in an AM2+ motherboard. This seems curious when you consider that the only chipsets on the market for AM3 Phenom II are AMD's 790FX/790GX combo so the differences between one motherboard and another are necessarily quite small.
/94/7512bd/3361/11457-twoboards.jpg
If you lay the TA790GX A3+ next to the TA790GX A2+ you will be hard-pressed to spot many differences as the major components have been carried over from the older model.

The two widely spaced PCI Express graphics slots are present and correct along with two PCI Express x1 slots and two PCI slots. The six SATA II connectors continue to be laid down at right angles to feed the SATA cables away from the graphics card(s). And, on the I/O panel the integrated HD 3300 graphics still have VGA, DVI and HDMI outputs and the on-board SidePort memory is still 128MB of DDR2.
/94/979e1e/71f9/11457-biostarta790gxa3iopanel.jpg
You'd need the eyes of an eagle to spot the change in the four memory slots from DDR2 to DDR3 but you can get a clue about the work of the Biostar development elves when you look at the chipset cooling. The bronze coloured heatsinks on the Northbridge and Southbridge have been carried over from the TA790GX A2+ but the TA790GX A3+ has also sprouted a cooler on the Voltage Regulation Module. Take a closer look and you'll see that Biostar has worked on the power hardware. In addition to the four-phase power on the TA790GX A2+ you now get an extra phase for the Northbridge and yet another phase for the CPU core that is intended to assist overclocking. Next to the DDR3 memory slots you'll see there are two more ferrite chokes (they're the grey cubes) that supply power more efficiently to the memory.

You may have spotted that the locations of the ATA133 and main power connector have moved slightly with the result that Biostar has created some space next to the main power block that is occupied by four LEDs. These Phase Status LEDS display the operation of the four-phase power which is interesting for a short time. Once you get bored with the disco lights you can disable them in the BIOS.

Next page
comments powered by Disqus